HomeMy WebLinkAbout1620 e brundage _envirotech report 6.22.20_74-126Bakersfield Transfer, Inc.
Standardized Hazardous Waste Facility Permit, Series B
Effective Date: April 7, 2008
Page 19
(8) If any sample shows a PCB concentration of 5 ppm or greater,
the Permittee shall provide the written test results to DTSC within
seven (7) days of obtaining the test results.
(9) The result of the PCB testing specified in this section shall be
valid only if no additional loads of used oil are added to the
storage tank from which the sample is taken. If additional loads
of used oil are added to the storage tank, a new sample shall be
taken and the PCB testing conducted again.
b. If the Permittee elects to have the receiving facility test the used oil for
PCBs and the receiving facility agrees to test the used oil for PCBs in
accordance with this Condition H, the Permittee shall provide written
instructions to the receiving facility that directs it to test the used oil for
PCBs to ensure that the used oil load does not contain PCBs at a
concentration of 2 ppm or greater. The instructions shall, at a
minimum, direct the receiving facility to do all the following:
(1) Take a sample for PCBs testing directly from the Permittee's
used oil load and test the Permittee's used oil load separately
from any other load.
(2) Do not unload the truck or commingle the Permittee's used oil
load with any other used oil at the receiving facility until PCBs
testing indicates that the Permittee's load does not contain PCBs
at a concentration of 2 ppm or greater.
(3) Use EPA test method 8082 or other similar methods approved by
the United States Environmental Protection Agency or DTSC to
test the used oil.
(4) Write the manifest number on the written test results for the used
oil load that was tested.
(5) Provide the Permittee with written test results within 24 hours
after the test has been performed. The written test results shall
clearly show whether or not the used oil load contains PCBs at a
concentration of 2 ppm or greater.
(6) Reject the load if the test results show that the used oil contains
PCBs at a concentration of 2 ppm or greater.
(7) Provide a signed certification, under penalty of perjury, for each
set of test results, to the Permittee stating that the receiving
facility has followed all of the Permittee's written instructions for
each used oil load received from the Permittee.